www.fastmarinamagazine.com

My friend has just refitted his 1.8 engine back in after a full engine rebuild. It runs fine but there is a lot blowing and water coming from the breather tube.
Any suggestions, thanks for any help

Does anybody know the part number for the oil pressure switch on my 1275/1300cc eng number 12v966el019312 thanks to all

thanks for your help

So both have a center mounting

Is the early Marina prop shaft similar to the Ital i.e. has a center mounting or is it just one piece thanks

Thanks for your help

My original one was broke and this one is a replacement which is in good condition, would any size exhaust pipe fit like a Morris Minor, or does it have to be a Marina which are harder to come by. Thanks for your help

I have a number on the casting 12g2395

Thanks for your help, did all marinas have a brake servo fitted then

The reason i ask my exhaust manifold does not have a servo pipe so is this an early manifold, or maybe it is not a marina manifold but a Austin manifold maybe

Does anybody know if the marina 1275 exhaust flange is the same size as a Morris minor flange , there more available if so or are they different sizes thanks for your help

Thanks again Chris will have a look

I am trying to fit a header tank to my cooling system, and i need a thermostat housing with a 8mm outlet to go back to the header tank to vent any air. i have seen a Maestro/ Montego with a outlet pipe on the housing does anybody know if it would fit a 1275cc engine or is there any thing else i coul...

Hi would you be willing to post one to me and the cost to Manchester

I need a starter motor for my 1275cc, i think it should be 9 teeth,would one from a Mini or Morris Minor fit