Fast Marina Magazine

Hello Forum

Can someone plse advise what make/type of coolant to purchase for my Marina 1974 1.3 Coupe - Also, the strength required on filling (50/50?)

In addition can anyone advise where the cylinder block drain plus is situated and what this actually looks like

Thanks, Billy S

Hi Frank

That fine - Can you PM me a contact number for your goodself?

Billy

Dear Forum

Does anyone know where I can source the above and the cost (pref without drain holes) for my Mark1 1974 1.3 Marina Coupe

Cheers, Billy

Thnks Dave
Much appreciated! Anyone know where the best place to get the badges?

Cheers, Billy

Dear All,

Can anyone plse advise me on the correct type and position of the rear boot badges for my Marina Coupe Mk1 1.3 Deluxe.

Many thanks, Billy

Hello All

Can anyone help with the following:
I have now put the car in the garage and went to start her for the first time in 2 weeks. I pulled the choke out turned the ignition and she fired first time,as I started to put the choke in she felt a bit lumpy and then stalled

For the life of me I ...

Marina Coupe deluxe on a 74 plate (Single Carb)

Can anyone plse tell me the diameter of the fuel pies feeding into the fuel pump (their are 2)

Ive tried 8mm and 7mm and the pipes are still loose

Thanks, Bills

Thanks Guys
USspecGT, did you also use wood for yours?
Thanks, Billy

Dear All

My front parcel shelf has rotted due to rain water. Can anyone advise the best material to use so I can make another

Thanks, Bills (74 1.3 Coupe)

Hi Paul

My 74 Coupe has no jacking points so would it be for this?

Billy

Many Thanks

Where can I get a new clutch slave from?

Thanks

Dear All

My clutch reservoir is bone dry and a wet patch has appeared under the car
Any ideas where it could be leaking from and is this a common fault?
Car is a 1974 1.3 Coupe Manual

Thanks, Bills

HI
I will join soon so it will be 351 ishhh
1974 Coup 1.3 Manual
Billy

Thanks Paul
Sent you a PM - Hope you received it!
Thanks, Billy

Can anyone plse help
"Engine and gearbox mountings gone soft" - Is this the rubber that fits inside the brackets?
If so can someone plse advise where I can source these

Many Thanks, Billy S (1.3 1974 Coupe)