I have located some 27mm spring steel to make new torsion bars.
It will be cheaper on a bulk buy.
Who is interested.
Raw material is $20.00 per metre.
Keep you posted on machining costs
new torsion bars
Moderators: ClaytonSpeed, balmy
new torsion bars
Marina 6 one day,V8 the next
-
JubileeNut
- FMM Supporter
- Posts: 5229
- Joined: Tue Jun 05, 2007 7:14 pm
- Location: Worthing, West Sussex, UK
Re: new torsion bars
Blimey!
That's a big job?
Is there a need for many out there?
Post some pictures up of any you get made
That's a big job?
Is there a need for many out there?
Post some pictures up of any you get made
" Pru, Its Kicking off "
1973 Morris Marina TC Jubilee
2013 BMW 328i M Sport F31
1973 Morris Marina TC Jubilee
2013 BMW 328i M Sport F31
-
MarinaCoupe
- Posts: 10258
- Joined: Thu May 31, 2007 5:26 pm
- Location: Bedford
- Contact:
new torsion bars
If you are going to make them to 10cwt Commercial spec (thicker), I could be interested. It would depend on the cost.
Chris
http://www.marinacoupe.co.uk
Chris
http://www.marinacoupe.co.uk
Re: new torsion bars
Hi Guys,
Machining costs for splining will be @ $160.00 per spline.
This will be reduced if we have more volume.
If I send them front setup this will reduce cost also.
We will be doing 1 set for Bathurst race car & one for me
Machining costs for splining will be @ $160.00 per spline.
This will be reduced if we have more volume.
If I send them front setup this will reduce cost also.
We will be doing 1 set for Bathurst race car & one for me
Marina 6 one day,V8 the next