Fast Marina Magazine

Great progress Lee, looks really smart.
I assume the plan is new shells (since you're in that far) but to standard size?

Thanks im leaving the shells alone as they well within tolerance plus standard size ones proving hard to find.

Sent from my SM-G981B using Tapatalk

Fair enough. I'd normally say replace them as a matter of course but if you can't find good quality new standard size ones that rather forces your hand!

Could be a set of standard mains listed here http://www.bowdenengineparts.co.nz/pdf/bearings.pdf

Great work there, and well done with the 2 litre, they go really well.
For future reference I have quite an assortment of new bearing sets and I am pretty sure there are standard sets there.
Best luck.

Kilroy wrote:Great work there, and well done with the 2 litre, they go really well.
For future reference I have quite an assortment of new bearing sets and I am pretty sure there are standard sets there.
Best luck.

Thanks Kilroy im still keeping a look out for bearings, whilst the engine is still this far stripped , still no luck for standard size,plenty of oversized ones out there tho .

Sent from my SM-G981B using Tapatalk

https://www.fwthornton.co.uk/search?fil ... ambassador

Might help. These people were very helpful when I needed parts last year.

ClaytonSpeed wrote:https://www.fwthornton.co.uk/search?fil ... ambassador

Might help. These people were very helpful when I needed parts last year.

Thanks , forgot about the Ambassador.
Another lead i got was some of the Rover 820's had the O series in.

Sent from my SM-G981B using Tapatalk

All the O, M and T series bearings will inter fit with each other.

Nice work Lee, what did you use to paint the engine bay?

MARINAMAN480 wrote:

ClaytonSpeed wrote:https://www.fwthornton.co.uk/search?fil ... ambassador

Might help. These people were very helpful when I needed parts last year.

Thanks , forgot about the Ambassador.
Another lead i got was some of the Rover 820's had the O series in.

Sent from my SM-G981B using Tapatalk

Thanks Ben contacted this company and had everything i needed

Sent from my SM-G981B using Tapatalk

tathoarder wrote:Nice work Lee, what did you use to paint the engine bay?

Thanks just used Rattle cans mixed to match the paint code then clear coat lacquer over that

Sent from my SM-G981B using Tapatalk

MARINAMAN480 wrote: Mon Jun 28, 2021 5:14 pm

MARINAMAN480 wrote:

ClaytonSpeed wrote:https://www.fwthornton.co.uk/search?fil ... ambassador

Might help. These people were very helpful when I needed parts last year.

Thanks , forgot about the Ambassador.
Another lead i got was some of the Rover 820's had the O series in.

Sent from my SM-G981B using Tapatalk

Thanks Ben contacted this company and had everything i needed

Sent from my SM-G981B using Tapatalk

Ah excellent!

If I can be of further assistance on the build let me know.

Ben

FWT is owned by a mate of mine's family always very helpful and have enormous stock. They have been buying up closed down Garage/Dealer stock going back to the 20's/30's. Until they moved to the NBC site in Telford, a few years ago the shop at the bottom of the Cop in Shrewsbury had hardly changed since then. A real Aladin's cave. They did feature once with old Fuzz on Car SOS.
Dave

Certainly a good company all the bits i ordered arrived today

Sent from my SM-G981B using Tapatalk