Fast Marina Magazine

I will be looking for a new rear exhaust for my tc soon or over the summer! Does anyone still make them any more? And if im lucky enough to find one,how much should i expect to pay? Thanks in advance

if you know anyone in the trade they are reprduced by timax and are roughly 27 + vat trade . A lot cheaper than that at cost price

there was one on ebay australia, approx $25AUD new/old stock i dont lnow if the listing is still going or not
cheers

I got a stainless one made down here in Devon. Cost about £185 from memory.

Sent from my iPad using Tapatalk

Harry Hayes in the MMOC has had a bunch made up to match the originals (the bullet shaped ones). I think his are about £40.

The TIMAX deal sounds good Ray do you have a part number?

ive got it on a bunch i have in the loft, will look one out and give you the number.

I think from back in the day the old timax part number use to be MS108E,think the single front pipe for the 1.3 and the 1.8 where MS107.....but i cant remember the final letter :? Has anyone a idea where i could get the bend part that goes over the rear axle made in a bigger bore pipe?

Ray,

I think MarinaMadBaz had some swan neck sections made up at some point, why not PM him to see if he still has them.

MS108E seems to ring a bell for the rear section!

To my knowledge Timax no longer make exhausts for the Marina range. I did enquire with my local parts suppliers who use Timax for all their exhaust supplies and they found that they couldn't help. I can however get exhausts made to order in Stainless at a reasonable cost. Complete system for the Mumford is costing me £250 :roll: . If anyone wants some prices I will enquire tomorrow and get some posted up on here

Hi Gary, currently they are being reproduced by timax, that is where i got my batch from a couple of weeks ago.

MS108E is the right part number for Trimax - just looked at an old rear section which came off the Jubilee and it still has the label on it

just checked mine earlier, still the same number paul.