Page 1 of 1
new torsion bars
Posted: Thu Apr 19, 2012 4:08 am
by dazza2623
I have located some 27mm spring steel to make new torsion bars.
It will be cheaper on a bulk buy.
Who is interested.
Raw material is $20.00 per metre.
Keep you posted on machining costs
Re: new torsion bars
Posted: Thu Apr 19, 2012 7:41 pm
by JubileeNut
Blimey!
That's a big job?
Is there a need for many out there?
Post some pictures up of any you get made
new torsion bars
Posted: Thu Apr 19, 2012 8:39 pm
by MarinaCoupe
If you are going to make them to 10cwt Commercial spec (thicker), I could be interested. It would depend on the cost.
Chris
http://www.marinacoupe.co.uk
Re: new torsion bars
Posted: Fri Apr 20, 2012 3:40 am
by ado28
Shipping from down under is very expensive Chris
Re: new torsion bars
Posted: Mon Apr 23, 2012 10:21 am
by dazza2623
Hi Guys,
Machining costs for splining will be @ $160.00 per spline.
This will be reduced if we have more volume.
If I send them front setup this will reduce cost also.
We will be doing 1 set for Bathurst race car & one for me