O Series engine mounts

d13ker67 · Post by **d13ker67** » Sun Oct 09, 2011 8:16 pm

Did some one want some O series engine mounts i look on the want page could not fine anything. If there was your welcome to them, they came of my van with a 1.7 engine
[img

][/img]
[img

][/img]

Post by **balmy** » Sun Oct 09, 2011 8:29 pm

It was Ben.

ClaytonSpeed · Post by **ClaytonSpeed** » Tue Oct 11, 2011 8:46 pm

It was me. How much?

Sent from my iPhone using Tapatalk

d13ker67 · Post by **d13ker67** » Wed Oct 12, 2011 7:34 pm

You can have them ben i was just going to scrap them.

ClaytonSpeed · Post by **ClaytonSpeed** » Wed Oct 12, 2011 7:39 pm

Nice one. I'll pay the postage if you send me your paypal address.

Thanks!

Sent from my iPhone using Tapatalk

d13ker67 · Post by **d13ker67** » Wed Oct 12, 2011 7:47 pm

I should be going to the NEC on the sunday i can take them there, if any good just, got to confirm with the misess my grandsons birthday that weekend

Post by **MarinaCoupe** » Wed Oct 12, 2011 7:52 pm

Hi d13ker67

I have a set of the angled brackets 'O' Series for my T16 conversion, but I have never seen the flat plates before. Are they standard or were they used by someone to reposition the engine higher or lower?

d13ker67 · Post by **d13ker67** » Wed Oct 12, 2011 7:56 pm

I dont know they were on my van with a 1.7 engine in, now ive got the 1.8tc in there

d13ker67 · Post by **d13ker67** » Thu Oct 20, 2011 9:08 pm

Ben im going on the sunday to the NEC if you want me to take them or i will post just let me no

Fast Marina Magazine