Does anyone know the thread size for disc caliper bleed nipples? 3/8 UNF has been suggested or are they likely to be metric? I had the usual problem of rusted in, got them out ok but totalled them doing it.
I was thinking of getting some of the ones with the one-way valves in the top. Does anyone have experience of these, good or bad?
Bleed nipple thread size
Moderators: ClaytonSpeed, balmy
-
MarinaCoupe
- Posts: 10257
- Joined: Thu May 31, 2007 5:26 pm
- Location: Bedford
- Contact:
Re: Bleed nipple thread size
Yes 3/8" UNF.
Chris
Sent from my iPhone
Chris
Sent from my iPhone
Re: Bleed nipple thread size
ta very much for the sizing 